MDA Module of 7750SR Configuration
After the new MDA module is inserted into the IOM board slot, the 7750 Service Router system will automatically detect its model and the output will be as follows:
The above figure shows that the new MDA module is inserted into slot 1 of IOM board 3. The system automatically recognizes that the MDA model is m4-oc48-sfp, but its running status shows unprovisioned. The Provisioned Card-type needs to be configured. The model is the same. Equipped Card-type.
Configuration command: configure card 3 mda 1 card-type m4-oc48-sfp
Configuration command: configure card 3 mda 1 card-type m4-oc48-sfp
After MDA completes startup, it enters the running state, as shown below:
After completing the above configuration, confirm that the newly inserted board card is running normally, and then you can configure the interface, service, etc.