25G DWDM 10KM CH58 1531.12nm SFP Transceiver
Product Features
- Supports up to 25.78Gbps bit rates
- Hot-pluggable SFP28footprint
- CWDM DFB laser and PIN photodiode, Up to 10km for SMF transmission
- Compliant with SFP+ MSA and SFF-8472 with duplex LC receptacle
- Compatible with RoHS
- Single +3.3V power supply
- Real Time Digital Diagnostic Monitoring
- Operating case temperature:
Standard: 0 to +70°C
Industrial: -40 to +85°C
Applications
- 25GBASE-LR
Description
The SFP28 transceivers are high performance, cost effective modules supporting data rate of 25.78Gbps and 10km transmission distance with SMF.
The transceiver consists of three sections: a DFB laser transmitter, a PIN photodiode integrated with a trans-impedance preamplifier (TIA) and MCU control unit. All modules satisfy class I laser safety requirements.
The transceivers are compatible with SFP Multi-Source Agreement and SFF-8472 digital diagnostics functions.
Absolute Maximum Ratings
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
|
Storage Temperature |
TS |
-40 |
|
+85 |
°C |
|
Case Operating Temperature |
TA |
0 |
|
+70 |
°C |
|
Maximum Supply Voltage |
Vcc |
0 |
|
3.6 |
V |
|
Relative Humidity(Non-condensing) |
RH |
0 |
|
85 |
% |
Electrical Characteristics (TOP =0 to 70 °C, VCC = 3.15 to 3.46 Volts)
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Supply Voltage |
Vcc |
3.15 |
|
3.46 |
V |
|
|
Supply Current |
Icc |
|
|
600 |
mA |
|
|
Power Consumption |
P |
|
|
2 |
W |
|
|
Data Rate |
R |
- |
25.8 |
|
Gb/s |
|
|
Fiber Length |
L |
|
|
10 |
KM |
|
|
Transmitter Section: |
||||||
|
Input differential impedance |
Rin |
|
100 |
|
Ω |
1 |
|
Differential input voltage swing |
Vin,pp |
180 |
|
450 |
mV |
2 |
|
Transmit Disable Voltage |
VD |
2 |
|
Vcc |
V |
3 |
|
Transmit Enable Voltage |
VEN |
Vee |
|
Vee+0.8 |
V |
|
|
Receiver Section: |
||||||
|
Single Ended Output Voltage Tolerance |
V |
-0.3 |
|
4 |
V |
|
|
Rx Output Diff Voltage |
Vo |
180 |
|
450 |
mV |
|
|
LOS Fault |
VLOS fault |
2 |
|
VccHOST |
V |
4 |
|
LOS Normal |
VLOS norm |
Vee |
|
Vee+0.8 |
V |
4 |
Note:
- Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
- Per SFF-8431 Rev 3.0
- Into 100 ohms differential termination.
- LOS is an open collector output. Should be pulled up with 4.7k – 10kΩ on the host board. Normal operation is logic 0; loss of signal is logic 1. Maximum pull-up voltage is 5.5V.
Optical Characteristics (TOP =0 to 70 °C,VCC = 3.15 to 3.46 Volts)
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Transmitter Section: |
||||||
|
Center Wavelength |
λt |
λ -6.5 |
λ |
λ +6.5 |
nm |
|
|
spectral width (-20dB) |
△λ |
|
|
1 |
nm |
|
|
Average Optical Power |
Pavg |
-4.0 |
|
+2.0 |
dBm |
1 |
|
Laser Off Power |
Poff |
|
|
-30 |
dBm |
|
|
Side Mode Suppression Ratio |
|
30 |
|
|
|
|
|
Extinction Ratio |
ER |
5 |
|
|
dB |
|
|
Optical Return Loss Tolerance |
|
|
|
-12 |
dB |
|
|
Receiver Section: |
||||||
|
Center Wavelength |
λr |
1260 |
|
1610 |
nm |
|
|
Receiver Sensitivity |
Sen |
|
|
-12 |
dBm |
2 |
|
Los Assert |
LOSA |
-30 |
|
|
dBm |
|
|
Los Dessert |
LOSD |
|
|
-16 |
dBm |
|
|
Los Hysteresis |
LOSH |
0.5 |
|
|
dB |
|
|
Overload |
|
2 |
|
|
dBm |
|
Note:
- Average power figures are informative only, per IEEE802.3cc.
- OMA receiver sensitivity is informative. Shall be measured with conformance test signal for . BER =5E-5 .
Timing Characteristics
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
|
TX_Disable Assert Time |
t_off |
|
|
100 |
us |
|
TX_Disable Negate Time |
t_on |
|
|
2 |
ms |
|
Time to Initialize 2-wire interface |
t_2w_start_up |
|
|
300 |
ms |
|
Time to Initialize |
t_start_up |
|
|
300 |
ms |
|
Time to Initialize cooled module and time to power up a cooled module to Power level II |
t_start_up_cooled |
|
|
90 |
s |
|
Time to Power Up to Level II |
t_power_level2 |
|
|
300 |
ms |
|
Time to Power Down from Level II |
t_power_down |
|
|
300 |
ms |
|
Tx_Fault assert |
Tx_Fault_on |
|
|
1 |
ms |
|
Tx_Fault assert for cooled module |
Tx_Fault_on_cooled |
|
|
50 |
ms |
|
TX_FAULT Reset |
t_reset |
10 |
|
|
us |
|
Rx_LOS assert delay |
t_los_on |
|
|
100 |
us |
|
Rx_LOS negate delay |
t_los_off |
|
|
100 |
us |
Digital Diagnostic Specifications
|
Parameter |
Symbol |
Units |
Min |
Max |
Accuracy |
|
Transceiver Temperature |
DDDTemp |
ºC |
0 |
+70 |
±5ºC |
|
Transceiver Supply Voltage |
DDDVoltage |
V |
3.15 |
3.45 |
±3% |
|
Transmitter Bias Current |
DDDBias |
mA |
0 |
35 |
±10% |
|
Transmitter Output Power |
DDDTx-Power |
dBm |
-5 |
+5 |
±3dB |
|
Receiver Average Optical Input Power |
DDDRx-Power |
dBm |
-16 |
-3 |
±3dB |
Ordering information
|
Part Number |
Product Description |
|
BT-SFP28-LR4Cxxxx |
1470~1570nm, 25.78Gbps, LC, 10km, 0°C~+70°C, with DDM |
|
BT-SFP28-LR4ICxxxx |
1470~1570nm, 25.78Gbps, LC, 10km, -40°C~+85°C, with DDM |
Related products
$0.00
Nokia RRU Network Port RJ45 Dustproof Plug Seal...
Nokia RRU Network Port RJ45 Dustproof Plug Sealing Plug 821687A 825639A Purpose: These plugs are ...
Nokia RRU Network Port RJ45 Dustproof Plug Sealing Plug 821687A 825639A Purpose: These plugs are designed to protect the RJ45 network ports on Nokia RRU (Remote Radio Unit) equipment from dust and environmental damage, ensuring longevity and reliability. Our Services Cost-effective equipment Faster delivery Worldwide shipping Alternative supply Sample service Test and warranty For this model, we have new original, cost-effective compatible, and economical second-hand cabl...
$850.00 $790.00
100Gb/s QSFP28 ER4 40km Optical Transceiver
Features Hot Pluggable QSFP28 form factor Supports aggregate bit rate up to 103.125Gb/s LC Dupl...
Features Hot Pluggable QSFP28 form factor Supports aggregate bit rate up to 103.125Gb/s LC Duplex optical interface 4x25Gb/s LAN-WDM transmitter, EML laser,APD array detector Operating case temperature:0 to 70 °C Low power consumption <4.5W Applicable for 40km SMF connection without FEC All-metal housing for superior EMI performance IIC management interface Single +3.3V power supply RoHS compliant (lead free) Applications 100G Ethernet Other optical links Standards SFF8436,SFF...
$4.00
SMA adapter cable RG58 low-loss feeder cable
SMA to TNC RF adapter cable, TNC male to SMA jumper, RG58 low-loss feeder cable, GPS antenna exte...
SMA to TNC RF adapter cable, TNC male to SMA jumper, RG58 low-loss feeder cable, GPS antenna extension cable. SMA to TNC Cable RG58 SMA Male Plug to TNC Male Low Loss Extension Cable 12inch (30cm) TNC to SMA RF Coax Adapter Cable 50 ohm for Wireless LAN Devices Click on email or WhatsApp. Online customer service. Our Services Cost-effective equipment Faster delivery Worldwide shipping Alternative supply Sample service Test and warranty For this model, we have new original, c...
$0.00
Gigabit Single-Mode Single-Fiber SC Fiber Media...
Product Description This Gigabit Single-Mode Single-Fiber SC Fiber Media Converter (Pair) is a hi...
Product Description This Gigabit Single-Mode Single-Fiber SC Fiber Media Converter (Pair) is a high-performance photoelectric conversion device. It uses single-fiber bidirectional transmission technology to achieve full-duplex Gigabit Ethernet data transmission over a single optical fiber. Designed for long-distance, high-bandwidth network expansion scenarios, it is widely used in security monitoring, enterprise networking, campus interconnection, and other fields. Click on email or WhatsApp...